25
Click the
in the lower right corner to let the camera automatically
move to the lower left corner of PCB. On the basis of the image collected by the camera, confirm
that the cross center point of the current camera is outside the lower right corner of PCB, as
shown in the following figure:
Because the position of track 3 is not fixed, the position of the lower right corner should be set
for each program. First, after the board enters and is fixed, move the camera reticle position to
the lower right corner of the board, as shown above. Then click [System Configuration]-[System
Composition] in the menu bar, as shown in the following figure: