32
regular solder joints on both sides and complete display on one screen in the same window
area)
QFP: indicating the inspection frame of QFP IC. (it can only be used for QFP with regular solder
joints on four sides and complete display on one screen in the same window area)
If the component angle is not 45 degrees, check [Angle Registration] and pull the slider to rotate
the image angle and then make frame.
After making the frame or left-clicking the corresponding inspection frame, the debugging
window of the corresponding component frame will appear to modify the standard of the
component frame.
Click the
in the upper right corner of the interface. When the mouse moves to the
image, it will switch to the corresponding icon. At this time, when you double-click a certain
point on the image with the left mouse button, the center point of the camera will automatically
move to this point. To exit
, just right-click.
When dragging to make frame, try to adjust the angle, scale and position of the frame by using
the space button, ↑ button or ↓ button. Or click the eight directional arrows outside the image
frame to move the center point of the camera.
To exit the component box, just right-click.
The image on the right side of the interface is the thumbnail of PCB, and the yellow box above is
the position of the camera. Double-click the left mouse button at any position of the thumbnail,
and the camera will move to the double-click position.
Do not check [FOV Center] at the bottom of the interface before making the component frame.
Adjust the image scale at the top of the interface to make it suitable for editing the component, as
shown in the following figure:
When there are multiple splicing boards on a PCB board, we only need to edit a small splicing
board, and the thumbnail on the right side of the interface can also be enlarged and reduced by
[Image Display Scale] in the following figure: