NEC SV8300, Command Manual

Page: 90 / 804

3-34
NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE TITLE:
BASIC SERVICES
08
: Default
BASIC SERVICE SETTING DATA
032 When a dial-in incoming call from a tie line or DID line is
addressed to vacant levels or unassigned stations, the call is
routed to a predetermined station, Attendant Console or Voice
Response System 0
1 Restricted (ROT connection)
Predetermined station, DESKCON or
Voice Response System assigned by
CM51 Y=06, 07
034 Receiving Tone when the destination goes on-hook while a line
is connecting to a destination.
[For EU]
NOTE:
In Germany, you have to set setting data to 0.
0
1 BT
ROT
035 Toll Restriction for an outgoing call by Station Speed Dialing 0
1 Not provided
Provided
036 Buzzer indication when a call remains held at Attendant
Console over a preprogrammed period of time assigned by
CM41 Y=0>00 Buzzer indication for Automatic Recall
[8300R2]
0
1 Not available
Available
037 Select the detection method of incoming Ground Start trunks
Ring signal
NOTE: This is useful when AC induction is present on Ground
Start trunks.
0
1 Detect only, Ring cycle only
Detect Ring cycle and Ground Lead
040 SMDR output for Tandem call 0
1 Available
Not available
043 System Speed Dialing Security. Stored number display on Mul-
tiline Terminal for an outgoing call by System Speed Dialing. 0
1 Not displayed
To display
044 Toll Restriction for an outgoing call by System Speed Dialing 0
1 Not provided
Provided
045 Warning Tone sent to connected parties during Executive Right
of Way (Executive Override), Busy Verification or Attendant
Override 0
1 Only once
Every 4 seconds
046 Warning Tone sent to connected parties to alert Executive Right
of Way, Busy Verification or Attendant Override
• Three burst tone
[Other than New Zealand]
• One burst tone [New Zealand Only]
0
1 Not sent
To send
048 Passing Dial Tone facility
[8300R2]
0
1 Not available
Available
Continued on next page
APRIL/16/2010
CM08