NEC SV8300, Command Manual

Page: 146 / 804

3-90
NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE TITLE:
LAN DATA ASSIGNMENT
0B
FUNCTION:
This command is used to assign the LAN data for Maintenance port of CPU blade and VOIP port of
VoIPDB. Set each port by the operational pattern to be used. For details, refer to PRECAUTION (1) on
this page.
PRECAUTION:
(1) The table below shows the operational patterns for each setting port.
In default setting, the port to be connected is the VOIP Port. Therefore, change the port by CM0B
Y=001>91, 92 when connecting to the Maintenance Port.
Assign the commands of SNMP to the Maintenance Port.
SNMP information can be obtained from the Maintenance port and the VOIP port.
(2) CM0B Y=1XX is associated with setting the system data for Control Signals, and Y=2XX is
associated with setting the system data for Voice Packets.
Continued on next page

: To assign – : Not assigned ( ): Y number
FUNCTION
PORT
REMARKS
MAINTENANCE
PORT
VOIP PORT
• PCPro

(0XX)

(1XX)
Available to use both ports at
the same time
• IP Station and Legacy Terminal/
trunk connection
• IP Station (P2P connection)
• IPT (P2P CCIS)
• Remote Unit over IP
• Stand alone (more than 2 Units con-
figurations)
–

(1XX/2XX)
• SMDR (LAN Interface)
• PMS (LAN Interface)
• OAI

(001)

(101)
Not available to use both
ports at the same time
• SNMP

(001)

(–)
• SIP trunk –

(101/201)
APRIL/16/2010
CM0B