NEC SV8300, Command Manual

Page: 195 / 804

3-139
NWA-033623-001 Rev.8.1
91ch3002.fm
COMMAND CODE TITLE:
STATION NUMBER, TRUNK NUMBER, BLADE NUMBER
10
FUNCTION:
This command is used to assign station numbers, trunk numbers, and blade numbers to Physical Port No.
(Unit No. + Slot No. + Circuit No.)/Virtual Port No.
PRECAUTION:
(1) When deleting a station number (Single Line or Multiline Terminal), be sure to delete Call Pickup
data (CM16), ACD/UCD Group data (CM17) and Station Hunting Group data (CM18) in advance.
(2) After assigning the data for CD-2BRIA (ISDN Telephone), you must unplug the circuit blades,
then plug them again (After unplugging the circuit blade, you must wait for 30 seconds before
plugging the circuit blade again.).
(3) 5 or more digits station number should not be assigned when the following features are used.
• SMDR/PMS
• Front Desk Terminal
ASSIGNMENT PROCEDURE:
DATA TABLE:
+ 10YY + +
PHYSICAL PORT No. (UNIT No. + SLOT No. + CIRCUIT No.)/
+
+ +
STATION
EXE
ST
DE
DE
NUMBER
TRUNK
NUMBER
BLADE
NUMBER
(1-10 digits)
VIRTUAL PORT No. (3-6 digits)
Y STATION NUMBER (A) SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
00 TDM terminal/Trunk
registration
See “About Unit
number, Slot number
and Circuit number”
See “Setting
method of Port num-
ber/Station number in
Dual port mode”
XXYYZZ Physical Port num-
ber
XX: Unit number
(01-50)
YY: Slot number
(01-18)
ZZ: Circuit num-
ber (01-32)
X-
XXXX
XXXX
Single Line station number
(1-8 digits)
X: 0-9, A (*), B (#) CM12
CM13
Continued on next page
APRIL/16/2010
CM10