NEC SV8300, Command Manual

Page: 407 / 804

3-351
NWA-033623-001 Rev.8.1
91ch3004.fm
COMMAND CODE TITLE:
SYSTEM TIMER DATA
41
Y
1ST
DATA
MEANING DEFAULT
2ND DATA
INCREMENT
UNIT
TIMER
0 141 Conference (built-in
CPU) forced release
timer
[8300R2]
NONE 01 02 03 .........................................................24
1 hour
7 hours 1 2 3 ..........................................................24
NOTE: If this data is set to “00”, forced release is not provided.
142 D11 data receiving
time after PSW (For
DLC)
[8300R2]
NONE 03 04 05 .........................................................30
1 ms.
3 ms. 3 4 5 ..........................................................30
NOTE: When DESKCON is accommodated, set this
data to “06”.
144 Interval Time of Blade
Locking up check
[8300R2]
NONE 01 02 03 .........................................................10
8.6 seconds
25.8
seconds
8.6 17.2 25.8........................................................86
NOTE 1:
When no signal return from blade during four intervals of
transmission cycle, the system judges that the blade is
locked up and the blade reset is executed.
When this data is set to default, the blade reset is executed
about 100 (25.8 by four) seconds later after locked up.
NOTE 2: This data is effective when CM08>921 is set to “1”.
145 Timer that monitors a
start of DT300/DT700
Series
[8300R2]
NONE 03 04 05 .........................................................20
1 minute
3
minutes
3 4 5 ..........................................................20
NOTE 1: This data is effective only for power failure transfer with
a BRT.
NOTE 2: When a power failure is returned to normal condition
while Multiline Terminal for power failure is busy,
DT700 Series calling is kept between the time of power
failure restoration and the time set by this data.
Continued on next page
BLADE RESET
JANUARY/14/2011
CM41