NEC SV8300, Command Manual

Page: 388 / 804

3-332
NWA-033623-001 Rev.8.1
91ch3004.fm
COMMAND CODE TITLE:
CPU RS-232C PORT
40
NOTE 1: The setting of Port Location Numbers 4-7 are effective after the system reset or for 10 minutes
after this data setting.
NOTE 2: CM40 Y=00: 14 should not be assigned when using Built-in SMDR in Local Office of Cen-
tralized Billing-CCIS.
NOTE 3: When using CPU RS-232C port for PCPro, set the default to CM40 Y=01-06.
NOTE 4: When External Printer for PMS is connected, set the second data of CM40 Y=01-07 as shown
below.
- CM40 Y=01-06............1 (default)
- CM40 Y=07 .................0 (always ON)
- CM40 Y=08 .................Adjust for the baud rate of External Printer
NOTE 5: Set the second data of CM40 Y=07 as follows.
- When using a printer cable ..................... 0 (always ON)
- When using a cable except printer .......... 1 (As per CS signal input)
NOTE 6: CM40 Y=13 should be set to “0” for downloading soft key information from UM8000 to
CPU.
Continued on next page
: Default
Y
PORT LOCATION NUMBER
SETTING DATA
REMARKS
No. MEANING DATA MEANING
07 CS control 0
1
4
5
6
7
UNIT01 PORT1
UNIT01 PORT2
UNIT02 PORT1
[8300R2] NOTE 1
UNIT02 PORT2
[8300R2] NOTE 1
UNIT03 PORT1
[8300R2] NOTE 1
UNIT03 PORT2
[8300R2] NOTE 1
0
1
CS control is always
provided
As per CS signal
input
08 Data speed 1
2
3
4
5
NONE
1200 bps
2400 bps
4800 bps
9600 bps
19200 bps
9600 bps
09 Printout Status
[8300R5]
0
1 UNIT01 PORT1
UNIT01 PORT2 0
1 Disable
Enable
13 DRS signal sent
to terminal 0
1 High
Low
JULY/15/2011
CM40