NEC SV8300, Command Manual

Page: 147 / 804

3-91
NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE TITLE:
LAN DATA ASSIGNMENT
0B
(3) When setting the IP address for Maintenance Port (Y=0XX) and VOIP Port (Y=1XX), set the
segments for each using port respectively.
(4) There are the following conditions when setting the default gateway address by this command.
• Only one default gateway address can be set for the system.
• Set the default gateway address to the Maintenance port (Y=0XX) when not using VoIPDB.
• Set the default gateway address to the VOIP port (Y=1XX) when using VoIPDB.
(5) When setting the IP address (RTP) for VoIPDB by CM0B Y=2XX, the number of IP address that
can be set is different depending on the type of VoIPDB used as bellow.
• For PZ-64IPLA: Maximum of 4 IP address can be set (Y=2XX>00, 20-22)
(Set an IP address (RTP) every 16 voice channels to be used.)
• For PZ-128IPLA: Maximum of 8 IP address can be set (Y=2XX>00, 20-26)
(Set an IP address (RTP) every 16 voice channels to be used.)
• For PZ-64IPLC-A/PZ-128IPLC-A: Maximum of 1 IP address can be set (Y=2XX>00)
(6) When entering data with characters, the following characters can be registered;
Alphabet upper case (A-Z), alphabet lower case (a-z), numeric (0-9), symbol (! “ # $ % & ’ ( ) + ,
; = > ? @ [ ] ^ _ ‘ { } ~), Space, hyphen (-), period (.), slash (/), colon (:)
(7) When the CPU blade/VoIPDB/IP Station is connected to the port of switching HUB that Spanning
Tree (IEEE 802.1d) is enabled, communication failures shown below may occur.
Disable the Spanning Tree feature to the connection port on the switching HUB.
• IP Station fails to connect to SV8300.
• IP Station cannot communicate with the IP Station.
• IP Station cannot communicate with the SLT/Digital Multiline Terminal.
• Remote Unit cannot change over to the normal mode in the Remote UNIT over IP system.
Also, disable the Spanning Tree feature as for the following connections.
• Connections between Units
• Remote Unit/Dual CPU system/Failover
• IP trunk/SIP trunk
• Application connections such as PCPro/SMDR
NOTE: The character “CCC” cannot be registered.
FEBRUARY/29/2012
CM0B