General Product Description
Sopho 2000IPS
Release 12.2, August 2006
NEC Philips Unified Solutions
UPD
56 of 259
© NEC Philips Unified Solutions, 2006. All right reserved.
Reproduction in whole or in part is prohibited without the written consent of the copyright owner.
-
Internal hold tone: Available
-
Hold tone using DAT: Not available
The maximum station number which can be used in SMDR or PMS Interface is as
follows.
-
MP built-in SMDR/PMS on IP: 1020 stations
-
SMDR/PMS with AP00 on RS-232C: 504 stations
You can connect MAT to Remote Site via RS-232C or LAN.
SNMP is not available at Remote Site.
The IP Remote Site does not have DHCP server and client function.
The MJ/MN alarm indications are not available at Remote Site. If a fault occurs at
Remote Site, the fault is notified to the Main Site and MJ/MN alarm is indicated at the
Main Site.
The backup call routing mechanism, to translate numbers, is available also for calls
from main office to a remote site, when survival mode is active.
The Calling Number presented to the called party is the ISDN DDI number instead of
station number (e.g. 00356891234 instead of 1234). Calling Name information is not
presented.
SMDR call records for calls made by Remote PIM extensions while in survival mode,
are lost and will not be included in Management@Net Accounting application.
Conditions for Link Down Notice
Link Down Notice is available only for Dterm and DtermIP accommodated in Main
Site and Remote Site. This is not available for a single line telephone and Attendant
Console.
For message display, Dterm/DtermIP with 24-digit or more LCD is recommended.
16-digit LCD may not display all messages properly.
Notification message can be displayed regardless of idle or busy state of
Dterm/DtermIP, writing the message over the present display. After six seconds, the
display returns to the time display automatically.
The system detects a Link Down on the condition that UDP connection between Main
Site and Remote Site is interrupted. The Link Down is notified to the Dterm/DtermIP
at 20-50 seconds (time programmable).
When the link between Main Site and Remote Site is interrupted, the lamp of
Dterm/DtermIP button becomes the state as shown below. Then press the button, the
LCD of the Dterm/DtermIP displays the following.
COLOR AND STATE
OF BUTTON
STATE AND
OPERATION
L C D DI S PLAY
Red/Flashing
(Momentarily)
0.125 seconds ON-
0.125 seconds OFF
Link Down occurrence
-
Red/Flashing
(Slowly)
0.5 seconds ON-
0.5 seconds OFF
Press the button after
Link Down occurrence
Link Down to Site xx
(xx: Site No.)
Green/Flashing
(Intermittently)
0.125 seconds ON-
0.125 seconds OFF-
0.125 seconds ON-
0.625 seconds OFF
Remote Site is survival
mode after Link
restoration
-
