2-8 Setup and Operation
USING SYSTEM CONTROLS
The system controls are located on the front panel of the system (see Figure 2-8). Use these
controls to power on the system, to put the system in Suspend mode, and to reset the
computer.
Power Button
Press the power button to power on the system (see Figure 2-8). The power lamp lights
green, indicating that the system is in Full-Power mode.
The system automatically goes into its Power-On-Self-Test (POST) and checks system
components. One beep indicates that the system has successfully completed its power-on
test.
If a problem occurs, a series of beeps may sound. If this happens repeatedly after powering
on, power off the system and troubleshoot.
If a problem occurs and is not indicated by beeps, power off the system and troubleshoot.
NOTE:
If the system displays a message
indicating that system settings have changed, run
Setup (see “System Configuration” later in this
section).
Figure 2-8 System Lamps and Control Buttons