Option Installation 3-31
Installing an Additional 5 1/4-Inch Device
Install an accessible device into the device cage as follows.
1.
Remove the front panel as previously described.
NOTE:
To install a 3 1/2-inch hard disk drive in
the 5 1/4-inch slot, a 5 1/4-inch form factor drive
is required.
2.
Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
NOTE:
If the 5 1/4-inch device comes with
drive rails, do not attach them. Remove any rails
already attached. See the documentation that
comes with the device.
3.
Locate the device rails that ship with the system (not the drive rails that come on
the device.) Attach the rails to the sides of the device with the four screws that
come with the device (see Figure Section 3-27).
If installing an accessible device (diskette drive or tape drive), attach the rails to
the device so that the front of the device extends beyond the chassis and is even
with the blank panels on the front of the system.
Figure Section 3-27 Attaching the Device Rails
4.
Insert the device into the device slot from the front of the system unit, connector
end first.
