CHAPTER 3
ND-45492 (E)
Page 82
Revision 2.0
(2) When using the cable hole of the PIM
(a) Make the cable hole on the left side of PIM as shown in
Figure 006-3
.
Figure 006-3 Making Cable Hole on the PIM
(b) Bring the MDF cable up to the PIM0 through the cable hole (s) of the BASE and bring the MDF cable
up to the other PIM through the cable hole (left side) of each PIM.
(c) Connect the champ connector of each MDF cable to an LTC connector located on a PIM using the
screws provided, as shwon in
Figure 006-4
.
(d) Pare the sheath of each MDF cable and secure the shield to the front bracket on the PIM using tie
wraps, as shown in
Figure 006-4
.
NAP 200-006
Sheet 4/7
Cable Running to the MDF
Front
Cut off the plate.
File the projections.
Put in the edgings.
