Built-in AIT
79
Setting the Built-In AIT
- Setting with the DIP switch -
The DIP switch on the bottom of the Built-In AIT enables you to change the following
settings.
• DC Control (1) (Data compression setting) (Factory-set to ON)
• DC Control (2) (Data compression setting) (Factory-set to OFF)
1 2 3 4 5 6 7 8
ON
• Do not change the position of the switches 1 to 6.
Setting data compression - DC Control (1) -
Set whether the Built-In AIT’s data compression function
is enabled or disabled.
Use Switch 7. Setting Switch 7 to ON (factory-set to ON)
will enable the data compression function; setting Switch
7 to OFF will disable the terminator data compression
function.
Setting data compression - DC Control (2) -
Set whether control of data compression from the backup
software is enabled or disabled.
Use Switch 8. Setting Switch 8 to ON will disable control
of data compression from the backup application; setting
Switch 8 to OFF (factory-set to OFF) will enable control
of data compression from the backup software.
Switches 1 to 6: Drive Mode
Switch 7: DC Control (1)
Switch 8: DC Control (2)
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
