78
Built-in AIT
Setting the Built-In AIT
- Setting with the jumper pins -
Before installing the Built-In AIT into the 5.25-in. device bay, verify the settings of the Built-
In AIT.
An ID setting is necessary required to use IDE device integrated with the Built-In AIT.
Different IDE devices connected to the same IDE bus, have different IDs so that the
devices operate properly.
Available ID settings are MASTER, SLAVE, and CABLE SELECT. However, because the
Built-In AIT is connected to the same bus as the CD-ROM drive (MASTER), use the
SLAVE setting.
The ID can be set with jumper pins 1 to 3 on the rear of the Built-In AIT. (The ID is set to
SLAVE at the factory.)
4
5V
12V
GND GND
3
2
1
MASTER
SLAVE
CABLE SELECT
No Connection
IDE Interface Connector
Power Connector
Jumpers
Drive Setting
MASTER
SLAVE
CABLE SELECT