NEC N8100- 1241F, User Manual

Page: 61 / 358

General Description 2-29
4.
If your server uses onboard RAID feature, the following message is displayed to prompt
you to run RAID utility.
Press <Ctrl><M> to Run LSI Logic SoftwareRAID Setup Utility
Press Ctrl + M to run the utility. For detail explanation, see Chapter 4 for detail.
IMPORTANT:
The LSI Logic Software RAID Setup Utility is used to
manage the data stored in hard disk drive, or for maintenance. See
Chapter 4 for detail.
5.
If the POST detects the optional add-in card, it display the message prompting you to
launch the add-in card BIOS configuration utility. (Ignore the message. POST will
automatically proceed a few seconds later.)
Refer to the manual that comes with the optional add-in card for detail.
6.
If you set a password using the BIOS setup utility, SETUP, the password entry screen
appears upon successful completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable
the server to boot. In such a case, turn off the power and wait about ten seconds before
turning on to boot the server.
IMPORTANT:
Do not set a password before installing an OS.
7.
The OS starts when POST completes.