NEC N8100- 1241F, User Manual

Page: 177 / 358

Installing and Using Utilities 6-9
NEC EXPRESSBUILDER for DOS-based with Remote Console
This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based with
remote console.
NEC EXPRESSBUILDER contains the remote console feature that allows the system administrator
to set up the server from the management workstation (management PC) via the network or the
server's COM B (serial) port.
IMPORTANT:
„
Do not use this feature on any other computer than the server, or
on any other server obtained without the NEC
EXPRESSBUILDER. Doing so may cause a failure of the server.
„
When a keyboard is connected to the server, the remote console
feature is disabled. The NEC EXPRESSBUILDER determines that
the server has a console. (Nothing is displayed on the management
PC.)
„
If you fail to configure the disk array controller N8103-80F or 81F
from the remote console, try again using the server console.
„
The system may fail to operate with the transfer rate of 115.2 Kbps
for serial console redirection. Specify any other transfer rate than
115.2 Kbps.