2-34 Setup and Operation
Update the BIOS from the BIOS flash diskette as follows.
1.
Write down the Setup parameters currently set on the system.
2.
Turn off the system.
3.
Insert the flash diskette in drive A, and turn on the system.
4.
When the flash upgrade menu appears, choose “Update Flash Memory Area from
a file.”
5.
When the menu asks you to enter a path/filename, use the arrow keys to select the
“.bio” file, and press
Enter
.
6.
The utility asks for a confirmation that you want to load the new flash data into
memory. Select “Continue with Programming.”
7.
After the upgrade completes, remove the upgrade disk.
8.
Reboot the system and start the Setup program. Press <
F5
> to reset the BIOS
defaults. Then, use the copy of the Setup selections you made at the beginning of
this procedure to set the options.
See “NECCSD Bulletin Board Service” in the previous subsection for information about
using the bulletin board (available in the U.S. and Canada).
SCSISelect UTILITY
Select the SCSISelect utility at boot up. Press
Ctrl-A
as soon as you see the SCSI utility
information on the screen. When the BIOS information appears, you have gone past the
window and must reboot.
The SCSISelect utility sets termination. In addition, from the SCSISelect utility you can
perform the following:
format a new SCSI drive
configure the host adapter
set a new SCSI ID.
To set a new SCSI ID, select the SCSI Device Configuration menu. With the arrow keys,
select Send Start Unit Command. Change the unit ID number from no to yes.
The ID for the SCSI adapter board is 7 and the installed SCSI hard drive is 0.
LANDESK CLIENT MANAGER
LANDesk
Client Manager is provided with the PowerMate Professional Series system.
Summary of Contents for MT-2550-24874C
Page 13: ...xiv Contents ...