41
1
2
8-3-2. Position Adjustment of Anamorphic Lens
햲
Loosen each of the two large and small
knobs in the vicinity of the shaft of the
anamorphic lens holder, then using the
special tool that was supplied with the pro-
jector, adjust the position of the anamor-
phic lens so that the projection image is
projected through the center of the an-
amorphic lens. After the adjustment of the
position, securely tighten each of the two
large and small knobs so that the posi-
tion of the anamorphic lens does not shift.
햳
Loosen the hexagonal lens fastening screw of the
anamorphic lens holder, then rotate the anamorphic
lens so that the vertical lines and horizontal lines of
the center of the image projected to the screen be-
come level and perpendicular.
Loosen the hexagonal lens fastening screw after the
adjustment and check that the projection image is
roughly in the center of the anamorphic lens and
that the four corners are not rejected within the an-
amorphic lens.
If rejected, repeat Steps
햲
and
햳
and adjust.
