73
Network Type (Settings are required only when a wireless LAN is in use.)
Mode:
Used to select communication mode when a wireless LAN is used:
Infrastructure ------- Select when data transmissions are required with a multiple number of devices con-
nected through wired and wireless LANs via access point.
802.11 Ad Hoc ----- Select when data transmissions are required between a single set of projector and PC
only using a wireless LAN alone. This is a mode based on the wireless LAN standard
IEEE802.11.
Ad Hoc -------------- Select when data transmissions are required between a single set of projector and PC
only using a wireless LAN alone.
SSID:
Enter the ID of the wireless LAN in use. Data communications are available only with such devices whose SSID
matches the SSID you enter here. (Max. 32 alphanumeric characters)
* L/c and u/c are distinguished in the check of SSID.
Channel:
Entry is required when you select Ad Hoc or 802.11 Ad Hoc in the Mode field above. Enter a numeral between 1
and 14 corresponding to the working channel of your LAN. The number of working channels (frequency ranges)
varies country by country. Devices connected by a wireless LAN with each other should use the same channel.
TX Rate
Enter the applicable wireless transmission rate. Usually leave Automatic. Try to change the rate when transmis-
sions are unsuccessful.
WEP (Settings are required only when a wireless LAN is in use.)
WEP
Used to set up whether WEP (data encryption) should be used or not:
Disable ---- WEP (data encryption) is not used. Your transmission data could be tapped or intercepted by
others.
64bit ------- 64-bit long data is used as a cryptographic key.
128bit ----- 128-bit long data is used as a cryptographic key. Security is strengthened as compared with the
use of a 64-bit long data.
Notes:
• Use the same WEP as with the remote device (PC or access point) with which your projector makes wireless
communications.
• Image transfer rate will slow down when you use WEP.
