NEC HX4000, User Manual

Page: 139 / 210

5-50
Upgrades and Options
Figure 5-22. Removing Side Rails with Locking Tabs
C
A
B
Removing side rails with
locking tabs from a blank
panel tray
A Screws
B Side rails
C Blank panel tray
11. Set any device jumpers or switches on the device.
Refer to the installation procedures that came with
the device.
Notice: SCSI termination resistors for the 5 1/4-inch
devices must be installed in the last SCSI device of the
daisy chain cabling (top media bay A). All other 5 1/4-
inch devices must have terminators removed.
12. Using the four screws supplied with the drive,
reinstall the side rails just removed from the blank
panel tray (Figure 5-23, A). Attach the rails to each
side of the device (C) by using only the bottom screw
holes, as shown. The rails for each side of the device
are identical.
13. Insert the device side bay rails into the bay
guide rails (see Figure 5-24). Ensure that the device
side rails (see Figure 5-24, A) are inside the bay
guide rails exactly as shown in Figure 5-24, B.
14. Push the drive into the bay (see Figure 5-21,
C).
15. Reinstall the two drive rail locking screws.