NEC Express5800/120Re, User Manual

Page: 291 / 346

Upgrading Your Server 9-37
8.
Insert the riser card assembly into the slot on the mother board.
Align the riser card terminal section with the slot on the mother board, and firmly push the
riser card until it is fully seated.
NOTE:
There are catches on the riser card frame that are used to
secure the riser card to the cabinet. When inserting the riser card,
confirm that the catches are correctly fit into the holes on the rear of the
cabinet. After the insertion, push the riser card with your fingers until
you cannot see any part of the riser card terminal section. The riser card
is now fully seated in the slot.
9.
Install the components you removed previously.
10.
Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
11.
Run the BIOS SETUP utility and select "Yes" for [Advanced]
→
[Reset Configuration
Data].
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
Removal
Remove a PCI board in reverse order of the installation steps.