6-8 Setting System Board Jumpers
4.
Remove the jumper block from pins 4-5 and set it on
pins 5-6. We recommend that you use needle-nose pliers
to move a jumper.
CMOS Clear Jumper
5.
Replace the access cover (see “Replacing the Access
Cover” in Chapter 5).
6.
Connect system power cables and monitor.
7.
Power on the system. The system boots.
8.
Power off, unplug the system and monitor, and remove
the cover.
9.
Remove the jumper block from pins 5-6 and replace it
on pins 4-5.
10.
If you removed any expansion boards, replace them
(see “Installing an Expansion Board” in Chapter 5).
11.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
12.
Power on the system.
13.
Run Setup (see Chapter 4).
Clear CMOS (J9C1)
Normal Operation A
(Default)
Clear CMOS
A
6
5
4
3
2
1
Jumpers
6
5
4
3
2
1