Setting System Board Jumpers 6-7
11.
Replace the access cover. Reconnect the system power
cables and peripheral devices.
12.
Power on the system.
13.
Run Setup (see Chapter 4).
Clearing CMOS
If you want to return your system to the factory default
settings, use the following procedure to clear CMOS.
!
CAUTION:
Clearing the BIOS changes your setup configuration
including hard disk settings.
1.
Turn off the power and unplug the system and any
peripherals.
!
WARNING
Turn off the system before you change any jumper
settings
2.
Remove the access cover (see “Removing the Access
Cover” in Chapter 5).
3.
Locate the CMOS Clear jumper (J9C1-A) on the system
board (see “Locating Jumpers” in this chapter).
You may have to remove any installed expansion boards
to access the jumpers (see “Removing Expansion
Boards” in Chapter 5).
