Native Instruments MASCHINE MK3, Manual

Page: 790 / 891

15.2.4 Arming, Starting, and Stopping the Recording on Your Controller
Starting and stopping the recording.
►
Press Button 5 ( START ) to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the
MODE selector, see section
↑
15.2.2, Selecting the Source and the Recording
Mode above):
▪
When recording in Sync mode:
◦
The recording will start at the next bar. Until then Button 5 flashes, the label under it
reads
WAITING , and a WAITING FOR NEXT BAR… message appears underneath.
◦
Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section
↑
15.2.2, Selecting the Source and the Recording Mode
above). You can also press Button 5 ( STOP ) beforehand to stop the recording at the
next bar, or Button 6 ( CANCEL ) to cancel the recording (in that case the recorded au-
dio will not be saved).
▪
When recording in Detect mode:
◦
The recording will start as soon as the input signal exceeds the THRESHOLD value.
Until then Button 5 flashes, the label under it reads WAITING , and a WAITING FOR
INPUT… message appears underneath. During this waiting phase you can also start
the recording manually by pressing Button 5 ( WAITING ) or cancel the recording by
pressing Button 6 ( CANCEL ).
Sampling and Sample Mapping
Recording a Sample
MASCHINE - Manual - 790