Nabco GT20, Programming Manual

Page: 45 / 50

Rev. 10-7-16 Part #C-00140
www.NabcoEntrances.com GT20 Control Wiring and Programming Manual
Troubleshooting 10-43
Table 10-3
Safety Sensors
No Description Cause Elimination Checking Time Reaction
E20 01 SER Test SER Test signal unsuccessful SER short-circuit to the
earth. Check the cabling of
the sensor or the jumper
Prior to closing A
02 SER too slow SER reacts too slowly Check
the cabling of the sensor
Check for polarity reversal/
test signal
E20-01 and
E20-02 together,
no line in between,
like E21
E21 01 SES Test SES Test signal unsuccessful SES short-circuit to the
earth Check the cabling of
the sensor or the jumper
Prior to opening A
02 SES too slow SES reacts too slowly Check
the cabling of the sensor
Check for polarity
reversal/test signal
E22 01 NOT Test NOT input on 24 V Check the jumpter NOT
Check the cablinf of NOT
Permanent H
02 Malfunction Restart the control unit
SW Update necessary
After Power Up
Table 10-4
Power
No Description Cause Elimination Checking Time Reaction
E30 01 30 V Error 30 V too low Mains failure, overload
motor Check 115 VAC
line. Replace hardware
Permanent A
02 30 V too high
03 Error upon switching-on After Power Up
E31 01 24 V General Error upon switching-on Overload, short-circuit of
the 24 V inputs
(without electric lock,
Safety Sensors)
After Power Up A
(Restart after
10 s)
02 Over-resp under-voltage Permanent
E32 01 24 V Safety Over-resp under-voltage Overload, short-circuit
Safety Sensors
E33 01 24 V E-Lock Error:
Over-resp under-voltage
Overload, short-circuit
electric lock
02 Premonition:
Over-resp under-voltage
W
E34 01 24 V CAN Over-resp under-voltage Overload, short-circuit
external power supply
CAN
Table 10-5
Option
No
Description Cause Elimination Checking Time Reaction
60 00 Relay PCB 0 Option PCB has been
removed, its address
changed or became
defective
X
Check if the option is provided.
X
If defective: Replace or remove
from the configuration.
Permanent W
10 Relay PCB 1
W
20 Radio PCB W
30 Fire-Protection A