Multitech ProxyServer MTPSR1-202ST, User Manual, Page: 103 / 142

Appendixes
103 MTPSR1-202ST
Command Function
Command Execution
AT
Attention code
Return Command execution
+++AT<CR> In-band escape code
<BREAK> AT
<CR> Out-of-band escape code
Switch Configuration
%A97
Dialing method
!C0 Switch type
!C6 Data SPID
*!C6 Voice SPID
!D3 SAPI-0 data TEI
*!D3 SAPI-0 voice TEI
!L List DN, SPID, TEI, Data protocol and switch type
>D=n Embedded Protocol Analyzer
!N1 Data directory number
*!N1 Voice directory number
!RXG Receive gain
!TXG Transmit gain
!Z=n Rate adaptation protocol
Serial Port Configuration
En
Command mode echo
L List telephone numbers
L5 List current operating parameters
L6 List S-register values
L8 List low-level ISDN status
Qn Status displays
Sr=n Set S-register
Sr? Read S-register
Vn Terse/verbose result codes
Xn Connect messages
Zn Restore parameters to current power-up profile
&Cn DCD (Data Carrier Detect) control
&Dn DTR (Data Terminal Ready) control
&En Flow control
#Xn Send Single Multiple Xoff Characters
&Fn Load quick setup factory profile
&M Asynchronous mode
&Rn CTS (Clear To Send) control
&Sn DSR (Data Set Ready) control
&Wn Store active profile
&Zn= Store telephone number
DSn Dial Stored telephone number
$Dn Persistent DTR dialing
$SBn Serial port speed
&Kn Data Compression
%En Escape sequence options
%Sn Serial port mode
@P3= Parity
@P4= Data bits
@P6= Stop bits
Data Call Commands
A
Answer
D Dial
&Jn Channel Bundling
H Hang up
In Display product information
On Return online
@Config Start ConfigMenu