Section E Ganging up Belarus – 90/92 Operating Manual
49
Additional suspension axes of lift
links of the hitch attachment
When cultivating high-stalk plants install
lift links (3) on addition suspension
axes. In this case for partial interlocking
of an implement in operational position
connect limiting chains (2) to the third
lowest hole of the bracket (1), and for
full interlocking to the fourth hole.
In transport position interlocking is
performed automatically.
Towing-hooking device TSU-1Zh
(crossbar) (4)
Towing-hooking device is used for hitching
machines operating at speeds of up to 15
km/h. Tractors as dispatched from the
works with a crossbar, installed as shown in
figure 1. To re-adjust from transport (I) to
operational (II) position, perform the
following operations:
1. Remove the cotter and pull out an
eyelet (3), then take off the crossbar
(4).
2. Remove the cotter and pull out a pin (2),
then take off rear ends of lift links (5).
3. Install the crossbar (4) on front ends of
lift links (1), secure it with the eyelet (3)
of the limiting chains, pins (2) and
cotters (see fig. II ).
When performing inside or outside
installation of limiting chains, provide full
interlocking of towing-hooking device. When
installing towing-hooking device
with
telescopic ties, connect them to the second
lowest bracket hole and provide full
interlocking.
ATTENTION! It is prohibited to use
yokes of the towing-hooking device for
operation with trailers at speed over 15
km/h.
IMPORTANT! Make sure that towing-
hooking device is secured from side
sway by means of adjustment of inside
or outside ties.
https://tractormanualz.com/
