Section E Ganging up Belarus – 90/92 Operating Manual
46
Partial interlocking of telescopic ties
ATTENTION! Telescopic ties should be
installed only in the second lowest hole.
To provide necessary lateral movement of
a machine, like a plough, in operational
position, make the following adjustments of
a tie:
• By rotating a screw (2), set the handle
(3) in the middle of flat «
В
»;
• Pull a cotter (5) out of the tie;
• Connect a machine to lift links (7) and
lift it until it rises off the ground;
•
After you have matched the holes of inner
tube (4) with the slot of outer tube (6), insert
the cotter (5) in the middle of the slot.
IMPORTANT! Set cotter (5) in the
middle of the slot, or with minimum
displacement towards the tractor.
Otherwise the ties can be damaged.
Before moving in transport position lift
machine into upper position and check
magnitude of its side sway, which should
not exceed 20 mm to each side. If
necessary, adjust the sway by rotating a
screw (2).
Full interlocking of ties
To fully interlock a machine, e.g. a
cultivator or trailing appliance, when in
operational position, adjust ties in a way
similar to partial interlock, except the last
operation, when you should matched the
hole of inner tube (4) with the hole of
outer tube (6), and then insert a cotter (5)
into the holes.
Full interlock in transport position (with
machine being lifted up), is made by
maximum screwing-in of a screw (2) into
the tube (4).
https://tractormanualz.com/