Section E Ganging up Belarus – 90/92 Operating Manual
44
Mounting machinery on tractor
1. Before mounting machine on the tractor,
first make sure there are no people in
the machine mounting zone.
2. Using draft control lever (if installed),
lower the hitch attachment into down
position, pull tractor back and hinge the
machine to lift links. Fasten the pins by
cotters. Shut down the engine.
3. Extend or shorten the top link (1) and
couple the hitch ball to the machine.
Fasten the pin by cotter.
4. If necessary, set the top link to initial or
required length.
5. If necessary, make lateral machine tilt
adjustment by means of right-hand
adjustable brace (2). To increase length
of the brace turn lever (3) clockwise,
and visa versa.
6. Before starting work make sure that:
• Parts of the tractor are not in
dangerous proximity to machine
elements;
• Top link is not in contact with PTO
guard, when machine is in
lowermost position;
• Cardan drive from PTO is not too
long, has no wide joints’ angles, and
there are no thrust forces;
• PTO guard is not in contact with the
guard of machine cardan drive.
7. Slowly lift the machine and make sure
that clearances between the wheel and
machine in lifted position are not less
than 100 mm.
8. Check whether the side sway of lift links
is sufficient and, if necessary, adjust it
by means of ties.
https://tractormanualz.com/
