Fitting the transport locking de-
vice on driving end (KS)
Note:
Attach plate (6) only to the upper part of the openings.
1.
Secure the plates (6) with screws (4) and washers (5) at the bores on both sides of the flywheel housing and
tighten to the specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M16
Tightening torque
250 Nm +25 Nm
2.
Screw locknut (2) onto screw (1) up to the end of the thread.
3.
The long side of holder (3) must face downwards. Insert holder (3) through openings in plate (6).
Note:
The holder (3) must lock the flywheel only, not the ring gear.
4.
Insert screw (1) in bores of holder (3) until holder (3) is secured.
Note:
The screw (1) must be tightened alternately on both sides of the flywheel housing.
5.
Tighten screw (1) to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M10
Tightening torque
30 Nm +3 Nm
6.
Place locknut (2) of screw (1) on plate (6) and lock it.
Removing the transport locking
device from driving end (KS)
1.
Release the locknut (2) on both sides of the
flywheel housing, remove screw (1) and take
off holder (3).
2.
Remove screws (4) and take off together with
washers (5) and plates (6).
3.
Store the removed parts of the transport
locking device carefully for possible reuse to-
gether with this documentation.
MS150123/01E 2017-05
| Transport | 23
TIM-ID: 0000073120 - 002
