mru SWG 100 SYNGAS, User Manual

Page: 44 / 129

USER MANUAL SWG
Page 44 of 129
•
Details (2): Here the operator can open the configuration screen for the
selected alarm output. To open the details-menu, push
F1
or
OK
.
•
Auto configuration (3):
If the operator pushes this key (
F2
) the output
pins would be configured by default values.
•
Test (4):
The test-menu is for testing the alarm outputs. To open the test-
menu, push F3 or OK .
The settings for an alarm-
menu. See the screenshot below.
Reference:
1 Section (1): Shows the operator, which alarm-output will be change.
2 Sample point (2): The operator can select the sample point. This means,
that the alarm-output signal from the choose sample point will be
transmitted to the process control system.
3 Meas. Item (3): At this point the operator selects the measurement item,
which should be monitored. At the chart below, the typical measurements
items are counted. Basically, all measurement-channels, which can be
measured, can be selected at this point.
2
5
7
1
3
4
6