Mr Beam Dreamcut II, User Manual

Page: 36 / 90

Page 30 04 - Setup Procedure
3. Lock the bracket
Then lock the cable with the bracket.
To remove the cable, first loosen the black
bracket again.
2. Insert the ribbon cable
Now insert the ribbon cable into the socket
on the back of the laser head. If neces-
sary, extend the black bar beforehand.
Finally insert the hose as well (only in the
“dreamcut“ modell).
Warning: The ribbon cable may only be
connected and disconnected if Mr Beam is
shut down and turned off! Failure to do so
will result in the inoperability of Mr Beam!
1. Mount the laser head
The laser head can be mounted at diffe-
rent heights, see Chapter 6 „Working with
your Mr Beam“.
First, mount the laser head in any position
at the bottom. Then slightly compress the
carriage and engage the laser head at the
top.
LASER HEAD CONNECTION