Mr Beam Dreamcut II, User Manual

Page: 14 / 90

Page 8 02 - Safety & Conformity
SAFETY PRECAUTIONS WHEN
OPERATING MR BEAM
Opening the lid during a laser job
When the protective cover is lifted or
opened, the power supply to the laser is
interrupted immediately. Opening the lid
during a laser job can lead to an incom-
plete work result, such as an incomplete
engraving. If possible, we recommend not
to interrupt a laser job.
Since vapors can escape when the lid is
opened during a laser job, first press
the button to activate pause mode. Then
wait briefly until the suction system has
removed all vapors. You can now open and
close the protective cover to continue the
operation by pressing the button again.
The following safety precautions must be
taken before each use of Mr Beam:
Combustible materials can be ignited by
the laser light. Therefore, all workpiece
residues must be removed after each
operation. The interior and immediate
surroundings of Mr Beam may not be
used as a store for flammable materials.
A fire extinguisher and fire blanket must
be available in the vicinity of the device at
all times.
The user must be present when perfor-
ming laser jobs!
Generally, only materials that have
been approved for processing by
Mr Beam Lasers GmbH via the link
www.mr-beam.org/en/materials/ may be
used.
Before putting the device into operation,
the user must clarify whether harmful
substances can be produced by the proces-
sing of materials which could damage
Mr Beam itself, the Air Filter System,
the environment and/or persons. If the
Mr Beam Air Filter System cannot filter
out harmful substances, you should not
use these materials. It is therefore the
responsibility of the user to comply with
national and regional limits for dust,
smoke and gases. For this, we recom-
mend Mr Beam Air Filter System.
Commissioning of Mr Beam is only
permitted with an appropriate suction
system (see Chapter 4 „Setup procedure“).
For information on how and at what inter-
vals to change the filter, please refer to
Chapter 7 „Maintenance and Care“.
The key is a convenient way to grant access
to Mr Beam only to authorized users.