Mr Beam Dreamcut II, User Manual

Page: 64 / 90

Page 58 07 - Maintenence & Care
REGULAR MAINTAINANCE & CARE
Regular maintenance and care is neces-
sary in order to maintain the high quality
results of your Mr Beam. In addition,
depending on the application and mate-
rials used, regular general cleaning
is necessary. Always turn off the unit
and disconnect the power plug before
commencing cleaning and maintenance
work.
Warning: There is a fire hazard due to
insufficient cleaning and remaining pieces
inside Mr Beam.
Regular maintenance & care
Please check before each use if dust
has accumulated in the interior of your
Mr Beam. If dust has accumulated, your
Mr Beam must be cleaned. Regular/daily
cleaning is recommended, the degree of
soiling strongly depends on the material
used. Only a regularly cleaned machine
can guarantee the best work performance
with optimum results.
To prevent dust from entering the inside
of Mr Beam when not in use, keep the lid
closed as often as possible.
Do not use aggressive or chlorine-cont-
aining cleaning agents for cleaning. We
recommend a mild soapy solution or the
use of commercially available detergent in
low concentrations.
Improper handling of chemicals can cause
damage to property and personal injury
for which the user alone is liable.
No tools are required for regular cleaning
and no parts need to be unscrewed.
Cleaning includes:
•
Remove all materials, dirt particles
and deposits from the interior of
your Mr Beam
•
Vacuum the working area to remove
residues from the grid floor
•
Dust all visible parts and surfaces of
your Mr Beam
•
Clean the safety cover only with a
cotton cloth/microfiber cloth. Do
not use paper towels as they may
scratch the acrylic
Caring of the guide bar
The mechanical guide bar must be regu-
larly cleaned of dust and dirt with a dry
cloth.
The guide bar must be oiled approximately
every 100 operating hours. Please note
that a small amount of machine oil (one to
two drops per rod) is sufficient. Only use
acid-free oils.