Mr Beam Dreamcut II, User Manual, Page: 20 / 90

Page 14 02 - Safety & Conformity
INTENDED USE
Your Mr Beam was developed for cont-
actless cutting and engraving of various
materials. These includes wood, acrylic,
cardboard, paper, leather, selected
plastics, anodized aluminum, etc.
For a list of approved and tested mate-
rials and thicknesses, please visit:
www.mr-beam.org/en/materials/
For safety reasons, only materials
approved by Mr Beam Lasers GmbH
are approved for processing in your
Mr Beam.
Operation is only permitted if Mr Beam is
in perfect condition (also see Chapter 2
„Safety & Conformity“).
The manufacturer accepts no liability for
any personal injury and/or damage to
property resulting from the inappropriate
or improper use of Mr Beam. Repair,
maintenance or opening of Mr Beam may
only be performed by persons who are
familiar with the intended area of applica-
tion and the dangers of Mr Beam, and who
must have received appropriate training.
Failure to observe the operating, main-
tenance and repair instructions set out
in this manual excludes Mr Beam Lasers
GmbH from any liability.
Warning: The processing of conductive
materials (e.g. carbon fibers) releases
dust particles and smoke, which can lead
to lasting damage to components and/or
electronics (e.g. short circuits). Proces-
sing of conductive materials will void the
warranty.
Materials containing chlorine, such as
PVC, release corrosive vapors during
processing, which can damage compo-
nents. The use of such materials, will
result in the exclusion of the warranty.
If you have any questions, please do not
hesitate to contact Mr Beam Support:
www.mr-beam.org/ticket
The technical data for the operator accor-
ding to OStrV (‚Arbeitsschutzverordnung
zu künstlicher optischer Strahlung‘
[german]) and EG/2006/25 can be found in
the technical data.