Mr Beam Dreamcut II, User Manual

Page: 39 / 90

Page 33 04 - Setup Procedure
Warning: Your Mr Beam must be connected
to a working suction each time it is used,
as processed materials are vaporized by
Mr Beam during laser operations. Burn
odors and vapors are therefore produced
during operation. Please make sure that
Mr Beam is operated exclusively with the
appropriate suction.
In the following, the suction is described with
two versions, the Suction System and the
Mr Beam Air Filter System. The suction
performance of both versions are cont-
rolled according to the presence of
exhaust gases. If a lot of exhaust gases are
produced during the machining process,
for example when engraving wood, the
suction performance is increased. This
is associated with a higher or fluctua-
ting noise level from the corresponding
suction system. The smoke concentration
is determined with an optical sensor. In
the event of a sensor error, the suction
capacity is increased to maximum for
safety reasons. Note that it is the respon-
sibility of the user to take the national and
regional threshold values for dust, smoke
and gases into account when selecting a
filter and suction system.
Suction System (without Air Filter)
The Suction System must not be used in
enclosed rooms. The exhaust air must be
able to be extracted from the working area
at any time (e.g. outdoors).
Warning: The end of the hose must
be fixed there so that no exhaust
air can enter the operations room.
It is important to ensure that the hose
outlet is led far enough outdoors to
prevent the exhaust gases from returning
to the interior. If smoke accumulates in
the device or strong smells develop, the
process must be stopped immediately and
the suction system checked.
The user must take into account the nati-
onal and regional threshold values for
dust, smoke and gases.
Mr Beam Air Filter System (with Air
Filter)
The Mr Beam Air Filter System allows
you to operate your Mr Beam indoors in
confined spaces without venting outside.
This ensures that no unfiltered exhaust
air escapes from your Mr Beam and that
the user is not endangered at any time.
It is necessary to change the Air Filter of
the Mr Beam Air Filter System regularly,
depending on the degree of soiling.
The Air Filter System must stand on a flat
ground and must not be covered.
SUCTION/AIR FILTER SYSTEM