Mr Beam Dreamcut II, User Manual

Page: 60 / 90

Page 54 06 - Working with your Mr Beam
MATERIALS & SIZE OF WORKPIECE
As already described in Chapter 2 „Safety
& Conformity“, hazardous vapors can be
generated during laser cutting of certain
materials. Therefore, it is particularly
important to process only materials that
have been declared suitable by Mr Beam
Lasers GmbH. An updated list of materials
can be found online at the following link:
www.mr-beam.org/en/materials/
Before commissioning Mr Beam, the
user must clarify whether harmful subs-
tances can be produced by processing
the materials used. If persons, your
Mr Beam and/or the Mr Beam Air Filter
System can be harmed by this, these mate-
rials can‘t be processed. If the Mr Beam
Air Filter System cannot filter out harmful
substances, it is not possible to use these
materials. It should be noted that it is
the responsibility of the user to comply
with national and regional thresholds for
dust, smoke and gases. Commissioning
of Mr Beam is only permitted with an
appropriate suction system (see Chapter
4 „Setup procedure“). For information on
how and at what intervals to change the
filter, please refer to Chapter 2 „Safety &
Conformity“.
Maximum size of workpiece
The maximum size of the workpiece is
500 x 390 x 38 mm (19.7 x 15.4 x 1.5 inches)
in length, width and height. Due to edge
blurring of the camera, positioning in the
center of the working surface is recom-
mended for smaller workpieces.