65
4)Take Off Basin and Basin Nozzle
The basin and its nozzle can be taken off for cleaning.
a)Turn the main switch off.
If the main switch is on, the sensor for the auto
filler will be activated and water will splash around
the area.
b)Take off the basin nozzle.
Hold the basin down and pull the nozzle straight up.
c)Take basin off.
Put your fingers in the gap between the basin and the top of the
basin unit and ease the basin up slightly. Then press down on the
top of the unit and pull the basin straight up and off.
If you do not hold down on the top of the basin unit
and use excessive force to take the basin off, the
swivel mechanism could be damaged.
Back of the Basin is base of the Dirt-repellent.
Please be careful if you scrub it or use hard or
sharp objects on it, it could be damaged.
d)Reverse the order of the steps above to reassemble.
Line up the indentation on the bottom of the basin with the projec-
tions in the top of the basin unit and carefully push the basin back
into place. Line up the pin on the nozzle with the groove inside the
basin and slide the nozzle all the way back into place.
If the basin is not put back properly, the nozzle will
not go back in. Ensure the indentations and pro-
jections on the bottom of the basin are correctly
line up.
If it seems hard to put the basin back in, coat the
rubber parts on the top of the basin unit with
Vaseline.
Pull nozzle
straight up
↑
Lift basin up
ADVICE
ADVICE
ADVICE
CHECK
[5]Operation 7.(5)
Main
Switch
（Lamp is out）
<Information>
Due to the manufacturing
method, you may be able to see
tiny bubbles in the surface of the
basin.