13
2. Foot Control
[5]Operation 2.
(1)Manual Chair Operation Levers
1)Operation
Use these levers to raise or lower the back rest and seat.
The chair moves only while one of the levers is actually being pressed.
The seat and back rest will stop automatically if they reach their upper
or lower limits. Release the lever when this happens.
2)Maximum Back rest Angle
The back rest normally goes up to a 70°angle, but it can be raised
up to 78° in the following way:
a) Hold the back rest lever until the backrest automatically stops at
70°.
b) Release the lever and then press it again to raise it up to 70°.
Back Up
CAUTION
Please do not assume any dangerous positions when riding on the foot control,
foot pedal or operation levers.
>>Not paying sufficient attention to the above points could result in injury or damage.
Once the foot control gets wet, do not use the same place again while it is still wet.
Please restart use after moisture has been wiped off with the main switch turned
off, and after it has dried naturally.
>>Not observing the above could result in injury, damage, electric shock or other
accidents.
Never place a load greater than 10N (1kgf) on the foot control, foot pedal or
operation levers.
>>Doing so could cause a malfunction or load to abnormal operation.
Please do not place the foot control on an incline or upside down.
>>Doing so could cause a malfunction or load to abnormal operation.
Seat Up
Seat Down
Back
Down
Back up