Monaco Camelot 2007, Owner'S Manual

Page: 195 / 258

11
Section 9 — electrical SyStemS - cHaSSiS camelot 2007
16. ATC (Automatic Traction Control):
The ATC indicator light will illuminate
steady when the ignition key is turned
ON. The light remains illuminated
until the first brake application. The
indicator flashes slowly when the ATC
switch is pressed. The indicator light
will flash quickly when an ATC event
occurs.
17. LOW WASH: Windshield washer
fluid is becoming low.
18. LOW AIR: Air tank pressures are out
of range. Check air pressure.
19. LOW COOLANT (NOT ON ALL
UNITS): Motorhome is low on
coolant. Check coolant temperature
and check level of coolant.
Parking Brake
The parking brake system is
activated when the push-pull
control knob (located on the
driver’s left console panel)
is pulled. When the knob is
pushed, the brake is released.
Prior to driving, allow time
for the air compressor to build
up sufficient air to shut off the
air warning lamp.
WARNING
If the air tank is not dumped, an
accidental release of the parking brake
could occur. Traveling with small
children and/or pets may require a
small block to be fabricated to prevent
accidental release. The block should be
placed under the knob and rested on the
dash panel. A wooden clothes pin (which
is not provided with the motorhome)
clasped at the base of the shaft works.
Switches
Driver’s Console
DRIVER SHADE:
Operates the power sun
visor located on driver’s
side.
PASS SHADE:
Operates
the power sun visor located
on the passenger side.
PEDAL IN/OUT:
Use the Pedal In/Out switch
to adjust the brake and throttle pedal to be
either closer or farther away. The switch moves
the pedals inward or outward approximately
three inches. If it is necessary to move the
pedals inward, push the same switch in the
opposite direction. When the pedal comes to
the end of the traveling distance there will be
a different sound in the noise of the motor.
Stop by releasing the switch. Do not continue
moving the pedals. Damage to the motor and/
or fuse may result if operation of the switch
continues after reaching the fullest extend or
retract position.
TAG AXLE:
(Optional Air or Hydraulic Leveling only):
The tag axle touchpad is integrated into the
(optional) air leveling control panel. Pushing
the Tag Lift button on the air leveling control
panel will raise or lower the tag axle.
Hydraulic Level Only:
Tag Axle Switch on
driver console raises and lowers tag axle. The
bar light on the switch is illuminated when the
tag axle is up.
NOTE
In certain situations, tag axle may
require to be in UP position. Raise the
tag axle when making sharp turns under
5 MPH.
Tag Axle Switch Positions:
Tag axle is down - bar light is not illuminated.
Tag axle is up - bar light illuminates.
NOTE
DO NOT drive the motorhome
over 5 MPH with tag axle raised.
The manufacturer will not be held
responsible for any damage that may
occur from driving with the tag axle
raised.
ATC: The ATC system improves traction on
slippery or unstable surfaces by preventing
excessive wheel slip. (See Section 10 for
detailed information.)
080313
060066n