Monaco Camelot 2007, Owner'S Manual

Page: 109 / 258

10
Section 5 — equipment camelot 2007
To operate the Stepwell Cover:
1. Chassis Battery Disconnect must be on.
2. Press and hold the Step cover switch to
the desired direction. Release the switch
to stop movement.
CAUTION
When operating the stepwell cover,
make sure there are no pets, shoes or
other obstructions in the stepwell area.
DO NOT operate the stepwell cover
while standing in the stepwell area.
Stepwell Storage Compartment
The interior stepwell
features a storage
compartment in the upper
step. This compartment
is ideal for storing such
items such as gloves (for
refueling), tire pressure
gauge, flashlights or outside
slippers.
graB HanDle
The grab handle is used to aid in entering and
exiting the motorhome.
WARNING
Clean the acrylic grab handle using
Soap and Water only! Do Not use
alcohol based glass cleaners as these
solutions adversely affect acrylic
material causing stress cracks leading to
eventual failure of the grab handle. Use
of alcohol based cleaners combined with
heat and light will expedite deterioration
of the acrylic material.
entry Door
The entry door is adjusted at the factory and
tested for all operations. The door incorporates
three separate seals to eliminate wind noise
during travel. The door uses two separate locks
for safety and security. One locking system is
the door handle and the other is a dead bolt.
The door handle incorporates a primary and
secondary latching system. This is used to
ensure secure and safe latching. There are
adjustments which can be made to help maintain
entry door performance.
Adjusting the Entry Door Latch:
Determine which bolt needs adjustment.
Slowly close the entry door observing
the latch and strike bolt alignment. Do
not attempt to latch if the alignment is
off. If the alignment is correct, allow
the latch to catch in the first (primary)
position only.
The latch should move to the second
position with only slight pressure applied
to the entry door. Upper and lower
latches should be evenly timed. Press
on the entry door to check for further
movement.
The entry handle should operate with
little effort to open the entry door.
Excessive pressure indicates the bolts are
set too far back.
With a box wrench or socket, loosen
the movable strike bolt. Make all
adjustments in small increments. Tighten
the bolt firmly after making adjustments.
The bolts should have slight up and
down movement for vibration control in





travel.
Test the operation of the dead bolt lock
to ensure proper functions.
Apply silicone weekly to the entry door
rubber gaskets to prevent squeaking
while the motorhome is in use. Use a 1”
sponge paint brush, sprayed with silicone
for easy application.
CAUTION
When operating the entry door, ensure
the dead bolt latch is fully unlocked
position prior to closing. Failure to do
so can result in damage to the dead bolt
and/or entry door.
Changing Screen Door Glass:
The screen slider is Lexan; the slider can
be bowed for removal and replacement.
Replace with new Lexan and reverse the
procedure.
Adjusting the Screen Door:
Loosen the bolts on the hinge side of the
screen door; two on the top and two on
the bottom.
The steel hinge has slots to allow
movement.
Four Phillips type screws are on the top
hinge, and four on the bottom hinge,
to adjust the screen door to properly fit
to the entry door. The hinge should fit
tightly to the trim of the door when the
screen door is latched to the door and the
door is open.







090344d