Monaco Camelot 2007, Owner'S Manual

Page: 103 / 258

appliances - 4
camelot 2007
Test Procedure
Before using the washer for the first time,
after winter storage or a long period of non-use,
conduct a simple test procedure to verify that
all the hardware and electronic components are
functioning. Wipe the interior and exterior of the
washer-dryer with a damp cloth to remove dust
that has accumulated.
NOTE:
Perform this test before putting the
washer-dryer in use for the first time
or after the winter months. This will
clear the water lines and drum of
winterization antifreeze.
Test Procedure Requirements:
Ensure water lines are secure and water
valves are open.
Hook to city water or turn on the water
pump.
Hook to shore power or start the
generator.



To Conduct the Test Procedure:
1. Set selector knob to Reset .
2. Set Dry Timer knob to 30 minutes.
Push the
ON/OFF
button to
ON
. Wait
five seconds. The Auto Dry light
should be on and the Status light
flashes fast, then slow.
3. Set the selector knob to a wash cycle.
Set
Wash Temp
knob to
Warm
. Water
should flow into washer and the drum
should rotate both directions.
4. Set selector knob to Reset . Wait five
seconds.
5. Set selector knob to Spin . Water
should drain and drum rotation should
increase.
6. Set selector knob to
Reset
. Wait five
seconds.
7. Set selector knob to Dry . Dryer fan
should begin and the drum should
rotate both directions.
8. Set selector knob to
Reset
. Wait five
seconds.
9. Set Dry Time knob to zero. The Auto
Dry light should go off.
10. The door will unlock in two minutes or
less. The Status light flashes fast, then
slow. The door should now open.
11. Push the ON/OFF button to Out (Off)
position. The Status light should be
off.
WARNING:
DO NOT wash or dry articles that
have previously been cleaned, washed,
soaked or spotted with gasoline, dry
cleaning solvents or other flammable or
vaporous substances that could ignite
or explode. DO NOT add gasoline, dry
cleaning solvents or other flammable
or explosive substances to the wash
water.
CAUTION:
DO NOT use heat to dry articles
containing foam rubber or similar
textured, rubber-like materials.
To begin a wash load:
Sort and pre-treat clothes.
Add the measured amount of detergent
suggested by the package directions
(maximum two tablespoons).
Load wash tray with detergent.
Load the laundry loosely into the washer.
Close the washer door.
Turn the Wash Temperature knob to the
desired temperature setting.
Choose the desired washing cycle option
using the Selector knob.
Turn the power ON .
After cycle is complete, wait two
minutes for the door lock to release
before attempting to open the door.








031017c