Monaco Camelot 2007, Owner'S Manual

Page: 221 / 258

217
Section 10 — cHaSSiS information
camelot 2007
Manual Leveling
The manual leveling mode can be used for
leveling or stabilization preference. An indicator
lamp adjacent to an extend switch indicates that
jack position(s) is low.
Manual Leveling Operation:
Follow the instructions in Prior to
Leveling .
Turn the ignition switch to On or ACC
position.
Press the
ON
/
OFF
button to turn the
system on.
Press and hold the MAN (manual) button
for five seconds. Once the indicator lamp
below the MAN button illuminates, the
system is ready.
CAUTION
Prior to leveling the motorhome it is
important that all jacks be in contact
with the ground to stabilize and support
the frame. No single jack should be
solely used to level the motorhome.
Applying an improper leveling process
can cause excess torsion stress and/or
twisting of the chassis, frame and body,
resulting in damage to the windshield or
an entry door malfunction.




Extend the front jack until contact with
the surface is made. Extend an additional
½". This allows the front jack to act as a
pivot point.
Extend the jack position according to the
indicator lamp. Example: If the indicator
lamp is lit under Jack Extend Switch
- Rear, the rear of the motorhome is low.
Press and hold the Rear button. Both rear
jacks will extend. Once level, the system
will automatically stop. The Power Gear
Level Light will illuminate. Release the
switch. Pressing Right or Left will extend
a single rear jack accordingly.
Turn off the remote panel.
Turn off the Ignition switch.
Automatic Leveling
The automatic function of the leveling system
should only engage when the site is relatively
level and solid to prevent excessive twist/stress
to the frame. It is essential that there is no
movement in the motorhome prior to and during
the automatic leveling process.
Automatic Leveling
Operation:
Follow the instructions in
Prior to Leveling .
Turn the ignition switch to
the On or ACC position.
Press the ON / OFF button
to turn the system on.







Press the Auto switch. The pump motor
activates and the appropriate jacks
automatically extend and level the
motorhome.
NOTE
A Jacks Down warning light will
illuminate when the jacks are extended.
The alarm will sound if the jacks are
down and the park brake is released or
transmission placed in gear.
The motorhome is level when the LED’s
next to Jack Extend switches are off
and the green Power Gear Level light is
illuminated.
Turn off the remote panel.
Turn off the ignition switch.
NOTE
If additional height
or surface support is
needed, construct a
1' x 1' wooden block
made from two pieces
of ¾" plywood for a
total thickness of 1½".
Drill a hole in one corner and use the
awning wand to slide the wooden block
under the jack pad.
Retracting Leveling Jacks
Turn the ignition switch to the On or
ACC position.
Confirm that the parking brake is applied.
Turn On the remote panel.







Wood Support Block
Wood Support
Block