Monaco Camelot 2007, Owner'S Manual

Page: 104 / 258

appliances - 4
100
camelot 2007
Washer/Dryer Maintenance
Occasionally wipe the exterior cabinet of the
washer-dryer with a damp cloth or sponge. Wipe
dry with a soft cloth. DO NOT use polish on
plastic trim. In areas of hard water, detergent
can accumulate in the drum. Obtain a packaged
water softener. Add quantity as specified by
the manufacturer directly to the drum. Run
the washer through a complete cycle using hot
water. Repeat the process if necessary. Remove
hard water deposits using only cleaners labeled
as washer safe. Wipe the inside of the washer-
dryer door with a soft cloth to remove moisture.
Periodically apply a thin coat of paste wax to
the inner door, especially to the area that is
immediately next to the door window. This will
protect the door finish from laundry spills and
discoloration.
If water flow to the washer-dryer is reduced,
the Hot and Cold water inlet screens may be
clogged. Remove water pressure and undo
water lines at the back of the washer-dryer.
Use tweezers or pliers to remove screens from
fittings. Clean and install screens and water
lines. Hook to city water or turn on the water
pump. Check for water leaks before using the
washer-dryer.
NOTE:
Should the washer-dryer need removal
for service, care should be taken as the
washer-dryer weighs approximately 170
lbs. Proper accommodations should be
made to avoid risk of injury or damage
to the cabinetry.
Winterizing the Washer/Dryer
Winterize Using Air Pressure:
1. Hook an airline (regulated to 45
psi or less) to the water inlet of the
motorhome.
2. Rotate Selector knob to a wash position
with the Wash Temp setting on Warm.
Press the power button to On. Air
pressure will clear the Hot and Cold
water lines.
3. After water lines are clear, rotate
Selector knob to Spin. Allow the pump
to drain the drum.
4. Set Selector knob to Reset and Timer
to zero. The door will unlock in two
minutes or less. Open door and pour in
¼ gallon of RV antifreeze.
5. Set selector knob to Spin. The pump
will prime with antifreeze. Set selector
knob to Reset and turn the power off.
central Vacuum (optIonal)
Operation
Start generator or plug into shore power.
Lift lid on wall receptacle to start
vacuum. Insert the hose in the receptacle
and release lid.
Connect desired attachment on hose and
start vacuuming.
NOTE:
Consult OEM manual for detailed
operation and maintenance.
Maintenance
Vacuum has a thermal protector built into the
motor to prevent overheating. If motor will not
operate, it will automatically reset in about ½
hour. If motor brushes or bearings are worn out,
the circuit protector will trip off again after a
short period of time. If this happens, contact a
qualified service representative.



031017b
water
screen
removal