Section 5 — equipment
112
camelot 2007
WARNING
Always use the pull strap for extending
and retracting awning. Never retract
awning while holding onto the awning
arm. Hands or fingers caught between
the awning arm channel and brace
channel during awning retraction may
result in serious injury.
3. Slide the inner bracing rafters to the
top of each arm ensuring the bracing
is locked in place. Tighten the black
locking knob.
NOTE
Ensure the locking tab on the support
brace is latched through in the hole in
the end cap.
4. If equipped with Canopy Clamps,
fasten the clamps at this time.
5. You can use the
arm extension
lock handle
to hoist the
awning upwards
for additional
clearance. Grasp
upper arm with
one hand and lift
slightly upward.
While lifting
upward, push in on
the release lever
located on the lower
portion of the upper
arm. Lift front of
awning to the desired
height. Support the
weight of the awning
with one hand while relaxing
release lever and allow the
engaging pin to set into a
hole in the lower arm. Go
to the other awning arm
and do the same. Ensure
the awning is straight.
6. Slide the center pull
strap to one end of the
awning and store it by
wrapping the strap around
the awning leg.
To Retract the Patio
Awning:
1. Loosen the strap from
the awning leg if it has
been stored there.
2. Support the weight of the
awning with one hand while
opening the extension lock
handle and lower the awning
until the arms rest on the lower
stop bolt. Loosen the two black
locking knobs enough to allow
the support brace to travel
freely.
3. If equipped with Canopy
Clamps, remove and store the
clamps at this time.
4. Release the locking tab on the end cap
of the awning leg and slide the inner
support brace down the awning leg to
the stop bolt. Repeat for opposite side.
5. While pulling down slightly on the pull
strap, slide the brake control down
(located on front awning leg).
6. Keeping downward pressure applied,
slide the pull strap to the center of the
awning while holding on to the strap.
7. Place the hook end of awning rod into
pull strap loop to assist in retracting
the awning. Make sure pull wand does
not slip out of pull strap loop, allow the
awning to roll up to the stored position.
8. Store the awning rod until it is needed
again.
9. Verify that the brake control is in the
locked or closed position. Snap the arm
storage locks into the down position
and tighten black locking knobs.
030844c
030841c
030841e
020219
Summary of Contents for Camelot 2007
