Monaco Camelot 2007, Owner'S Manual

Page: 68 / 258

Section 3 — exterior & interior care
camelot 2007
Tile Floor
Tile floors vary in porosity and surface
irregularities. Regular maintenance is important
to keep the tile in the motorhome looking
showroom new. Once the slide-out has been
extended, keep the tile floor clean to prevent dirt
from scratching the tiles prior to retracting the
slide-out.
NOTE
Tile is ceramic and will chip or break.
Avoid dropping heavy or sharp objects
on the tile.
Cleaning Tile:
Use a damp sponge mop or a cloth to clean
tile. If moderate staining occurs, cleaning with a
window cleaner such as Windex® should do the
job. A mild solution of hot water and all-purpose
cleaner for tile floors, walls and countertops can
also be used. Rinse well with clear water and
dry with a soft cloth to prevent streaking. Avoid
cleaning tile with soap. Soap forms a film to
dull the luster. Soap also promotes the growth
of mildew and bacteria.
DO NOT
use powdered
cleaners on unglazed tile floors. Undissolved
powder will dull the surface. Grout sealers are
available that protect the porous surfaces. If a
sealer is used, follow the sealant manufacturer
guideline for application. Never use sealers on
unglazed tile. With the exception of terra cotta,
which may be oiled or waxed, tile does not need
to be polished or buffed to maintain its finish.
NOTE
Before using any solution to clean
the tile, check the manufacturer’s
warning label to ensure safety of the
product. If there is any doubt, apply
several test patches of the solution in
an inconspicuous place to determine
product suitability.
Grout:
Grout used is a two part concrete mix and can
develop surface cracks over time. In motorhome
application, due to the constant flexing of the
flooring, this process may accelerate. If the grout
requires cleaning, scrub with a plastic brush.
DO NOT use steel wool as small particles may
remain and produce unsightly stains.
To Apply:
1. Extend slide room(s) and clean floor.
Allow floor and grout to thoroughly
dry.
2. Working from rear towards doorway,
apply sealant direct from container
onto a cloth towel or broom handle
applicator. Grout sealant applicators are
available at large hardware stores.
3. Apply only enough sealant to wet
surface. DO NOT allow sealant to
puddle in grout lines. Extra care should
be used to make sure all grout has
been sealed. Only one application is
necessary.
4. Allow five hours to dry. Sealant will
fully cure in 72 hours.
NOTE
If a spill occurs before sealant has
cured, it may be necessary to clean and
additionally treat area with sealant as
needed.