Section 5 — equipment
10
camelot 2007
Locate the slide-out room control switch.
Press and hold the slide room switch to
the desired (
IN
or
OUT
) position.
Release the switch anytime to stop
room movement. The drive motor will
not automatically stop; the switch must
be released. A change in motor sound
indicates full extension/retraction.
If applicable,
install any
lock bars for
travel.
CAUTION
Remove lock bar prior to extending
slide-out.
CAUTION
Continuous operation of the slide room
can drain the batteries and overheat the
motor.
WARNING
The outside area must be clear of
obstructions that can restrict slide room
operation. Ensure there is five or more
feet of clear space outside the slide room
prior to extending the room or damage
to the slide, the motorhome or property
can occur. When retracting the slide
room, ensure there is sufficient clearance
inside the motorhome. Move the driver
seat forward before activating the slide
room.
CAUTION
If a problem with the slide-out occurs,
contact a qualified technician.
Troubleshooting
If the slide room does not operate, a safety
feature may be engaged to prevent room
operation.
If the slide room does not respond from
the switch:
Is the ignition key OFF when extending
room to the OUT position?
Is the park brake applied?
If the slide room does not operate after
checking the safety requirements:
Ensure all electrical connections at the
slide-out switch are good.
Check the fuse
and auto-reset
circuit breaker
on the slide-out
relay module
located in
the curbside
electrical compartment. On 42’ tag
axle models the fuse and auto-reset
circuit breaker are located in the engine
compartment rear run box. Check the
slide-out relay fuse found in the roadside
front distribution panel.
House batteries are fully charged.
For hydraulic pump system (found on
42’ SFT models only) check fluid level
in reservoir. Maintain fluid within ½”
from top of reservoir when slide-outs
are completely retracted. Use automatic
transmission fluid (ATF) such as Dexron
5 or Mercon 3.
It may be necessary to contact a repair
facility to have the problem diagnosed
and repaired.
WARNING
DO NOT work on slide-out system
unless the battery is disconnected. Make
sure floor is clean before retracting slide-
out room.
Manual Override
Depending on floorplan the main slide-out
(living room) may have either an electric motor
system or a hydraulic pump system (found on
42’ SFT models only).
To Move the Main Slide Room (Electric
Motor System) Manually:
1. Access the slide room electric motor.
The motor is located in either a
curbside or roadside compartment,
depending on the floorplan. The motor
is at the top of the compartment.
2. Remove 12 Volt DC power from the
slide-out motor by disconnecting the
electrical plug. The plug can be located
by following wires that run from the
motor to the plug.
3. Attach a crescent wrench to the
electric motor drive shaft. Turn
counterclockwise to bring slide room
in, turn clockwise to move slide room
out.
4. Take motorhome to an authorized repair
center.
080429e
030802c
Summary of Contents for Camelot 2007
