Mold-Masters Fusion G2, User Manual

Page: 30 / 192

FUSION SERIES
®
G2 Safety Hazards - continued
WARNING
• Water and / or hydraulics on the mold may be in close proximity to
electrical connections and equipment. Water leakage may cause
an electrical short circuit. Hydraulic fluid leakage may cause a fire
hazard. Always keep water and / or hydraulic hoses and fittings in good
condition to avoid leaks.
• Make sure the lifting eyebolt, lifting chain and crane are rated to
adequately support the weight of the plate(s). Failure to do so can
cause a serious injury.
• All maintenance on
Mold-Masters
products should be performed
by properly trained personnel based on local law or regulation
requirements.
• Ensure proper grounding of all electrical products before performing any
maintenance to avoid potential risk of electrical shock.
• Make sure the machine has been locked out and tagged out in
accordance to the machine’s documented procedures. Failure to do so
may lead to serious injury or death.
• Check that all coolant, hydraulic and air lines as well as electrical cables
will not interfere with the moving parts of the mold, machine or robot.
The lines must be of sufficient length so that they will not strain or
pinch when the mold halves separate.
• For water cooling nozzle jacket, coolant must be maintained with the
proper mixture to prevent corrosion and circuit blockage.
• Care must be taken to ensure the nozzle terminal ends do not come in
contact with the hydraulic fluid. The nozzles may short out or become
damaged.
• Do not mix electrical power cables with thermocouple extension
cables. They are not designed to carry the power load or list accurate
temperature readings in each other’s application.
3-14
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
SAFETY
FSG2 User Manual