Mitsubishi MOTORS Lancer 2004, Workshop Manual

Page: 116 / 638

POWER STEERING GEAR BOX AND LINKAGE
POWER STEERING 37-32
REASSEMBLY SERVICE POINTS
>>A<< OIL SEAL INSTALLATION
1. Apply a coating of ATF DEXRON III or DEXRON II
to the both sides of the oil seal.
2. Using the following special tools, press the oil seal
into the rack housing.
•
MB991197: Bar (long type)
•
MB991199: Oil Seal Installer <Sport>
•
MB991202: Oil Seal and Bearing Installer
<Comfort>
>>B<< NEEDLE BEARING/LOWER
BEARING INSTALLATION
1. Apply ATF DEXRON III or DEXRON II to housing
and bearing press fitting surface.
CAUTION
Press-fit straight. The valve housing is
aluminium, and may become deformed if
press-fit on an angle.
2. Press fit needle bearing/lower bearing with the
following special tools.
•
MB990938: Bar (snap-in type)
•
MB991202: Oil Seal and Bearing Installer
>>C<< RACK ASSEMBLY INSTALLATION
CAUTION
Do not close the vent hole in the rack with
grease.
1. Apply a coating of repair kit grease to the rack
teeth face.
2. Cover rack serrations with the following special
tool.
•
MB991212: Oil Seal Protector <Comfort>
•
MB991213: Oil Seal Protector <Sport>
3. Apply ATF DEXRON III or DEXRON II to special
tool, and to the outer surface of the seal ring and
the O-ring.
4. Align the centre of the oil seal with the rack to
prevent the retainer spring from slipping. Slowly
insert the rack from power cylinder side.
AC100260 AD
MB991197
Oil seal
MB991202 <Comfort>
MB991199 <Sport>
Gear housing
ACX01153
Needle bearing
MB990938
MB991202
MB991202
Lower
bearing
AE
MB990938
ACX01154 AB
Seal ring and O-ring
Vent hole
ACX01155
MB991212 <Comfort>
MB991213 <Sport>
AG
Oil seal