Mitsubishi MOTORS Lancer 2004, Workshop Manual

Page: 344 / 638

HEADLAMP
CHASSIS ELECTRICAL
54A-66
HEADLAMP
SERVICE SPECIFICATIONS
M1542000300332
TROUBLESHOOTING
M1542000701281
Features the headlamp automatic shutdown function
to avoid battery drain when the headlamps are left
on. The main features are as follows:
•
Extinguishes automatically in three minutes if the
ignition switch is turned off with the lighting switch
on.
•
Extinguishes in one second if the driver's door is
opened within that 3-minute period.
•
If the headlamps are turned on with the ignition
switch off, the headlamps and tail lamps will
extinguish in three minutes after the driver's door
is opened or closed.
The headlamps are controlled by the Smart Wiring
System (SWS). For troubleshooting, refer to
respective Groups below.
•
Not using SWS monitor: GROUP 54B, SWS
Troubleshooting
P.54B-38 .
•
Using SWS monitor: GROUP 54C, SWS
Troubleshooting
P.54C-22 .
ON-VEHICLE SERVICE
HEADLAMP AIMING
M1542000900538
PRE-AIMING INSTRUCTIONS
1. Inspect for badly rusted or faulty headlamp
assemblies.
2. These conditions must be corrected before a
satisfactory adjustment can be made.
3. Inspect tyre inflation, and adjust if it is necessary.
4. If the fuel tank is not full, place a weight in luggage
room of the vehicle to simulate weight of a full
tank (0.8 kg per litre).
5. There should be no other load in the vehicle other
than driver or substituted weight of approximately
75 kg placed in driver's position.
6. Thoroughly clean the headlamp lenses.
7. Place the vehicle on a level floor, perpendicular to
a flat screen 10 m away from the bulb
centre-marks on the headlamp lens.
8. Rock vehicle sideways to allow vehicle to assume
its normal position.
9. Bounce the front suspension through three (3)
oscillations by applying the body weight to hood
or bumper.
10.Four lines of adhesive tape (or equivalent
markings) are required on screen or wall:
(1) Position a vertical tape or mark so that it is
aligned with the vehicle centre line.
(2) Measure the distance from the centre-marks
on the headlamp lens to the floor. Transfer the
measurement to the screen. Horizontal tape or
mark on the screen is for reference of vertical
adjustment.
Item Standard value Limit
Headlamp aiming Low beam Vertical
direction 0.69
°
below horizontal (H)
±
0.29
°
from the
standard value
Horizontal
direction Position at which the stat up point
of 15
°
is crossed with vertical line
(V)
±
0.5
°
from the
standard value
Measurement of headlamp illiminous intensity cd
−
30,000 cd or more
per one headlamp
AC304804
(1)
(2)
(3)
Headlamp centre line
Vehicle crntre line
Screen
(3)
10 m
In the centre
of headlamps
(1)
(2)
(3)
(3)
In the centre
of headlamps
AB
Vehicle centre line
Screen
Headlamp centre line
10 m